Connection and System requirements

Introduction to programming

Connection and System requirements

Commands for PC programming

Commands for Master-Slave programming

Master-Slave connection diagrams

Setting Up a Master-Slave Application

Example of programming and operation of single DPS

Example of programming Master-Slave application

Diagram for programming example

Schematic for molding Medical Implantable RF Coil

Graph - sequence of operation steps example

The example program - storing program to DPS processor

Connection diagrams and system requirements

 

 Figure 1. Controlling or programming the DPS 

 Figure 2. Application examples for electromagnetic brakes and clutches: Performance Testing, "Electronic" Performance Matching, De-cogging or data collection by motorized dynamometer and data transfer to DPS.

 

 Figure 3. Programming the DPS/ Program transfer 

 System requirements: 

• PC with Windows 2000/XP Operating System

• RS-232 Serial Port (in case RS232 serial port is not available use ATEN USB to Serial Bridge Adapter)

• Software: LabView®, MatLab®, Visual C++®, Visual Basic® or Hyper Terminal

• Hyper Terminal communication setup:

Figure 4. Communication port setting: serial port RS232 - usually COM1

               (if COM1 is not available use different port).

Figure 5. Hyper Terminal settings

                            

Figure 6. Input Translation – encoding method

     

Figure 7. ASCII settings – sending/receiving

Back to Top

---

Copyright © 2004  [MAGTORX]. All rights reserved. Rev. 1.1